![]() For example, generic operating systems, such as Red HatĮnterprise Linux or Microsoft Windows cannot boot on this appliance. Unsigned operating system even with physical access to the device. This featureĮnsures that only a Cisco-signed ISE image can be installed on the SNS hardware appliances, and prevents installation of any Therefore, to reimage a Cisco ISE hardware appliance withĬisco ISE software, you can do one of the following:Ĭisco SNS hardware appliances support the Unified Extensible Firmware Interface (UEFI) secure boot feature. The Cisco SNS hardware appliances do not have built-in DVD drives. Plug in the bootable USB device to the Cisco ISE appliance, restart the appliance, and boot from the USB drive to install Safely remove the USB device from the local system. Open ks.cfg file and replace the term “ cdrom” with “ harddrive -partition=/dev/disk/by-label/ADEOS -dir=/” Specifically, replace all instances of the " cdrom" string. isolinux/ isolinux.cfg or syslinux/ syslinux.cfgįor SNS hardware appliance, replace the term " cdrom" with " hd:sdb1" in both the files. ![]() There are two text files that you must manuallyįrom the USB drive, open the following text files in a text editor: After this process is complete, the content of the USBĭrive is available in the local system that you used to run the USB tool. The progress bar indicates the progress of the bootable USB creation. Plug in the USB device to the local system and launch Rufus.įrom the Boot Selection drop-down list, choose Disk or ISO Image.Ĭlick Select and choose the Cisco ISE ISO file.įrom the Partition Scheme drop-down list, choose MBR.įrom the Target System drop-down list, choose BIOS or UEFI. Reformat the USB device using FAT16 or FAT32 to free up all the space. Before you beginĭownload the Cisco ISE installation ISO file to the local system. You can download Rufus from the following location:Ĭisco ISE 3.1 patch 6 and later versions support Cisco SNS 3700 series appliances. If you are installing Cisco ISE on Cisco SNS 3700 series appliances, you must use Rufus 3.18 to create a bootable USB deviceįrom the installation ISO file. You can download Fedora Media Writer from the following location: You can download LiveUSB-creator from the following location: You can download Rufus from the following location: If you are installing Cisco ISE on Cisco SNS 3700 series appliances, you must use only Rufus to create a bootable USB deviceĬisco ISE 3.1 patch 6 and above, and Cisco ISE 3.2 patch 2 and above support Cisco SNS 3700 series appliances. Tools Used to Create Bootable USB Deviceįedora LiveUSB-creator for SNS 3500/3600 series appliance The following table shows the tools to be used to create a bootable USB device from the installation ISO file in different Tools Used to Create Bootable USB Device from Installation ISO File
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |